Canada flag
United States flag

Slide Bearing Material Selector: PTFE vs Graphite

Choosing a sliding surface for a slide bearing or expansion bearing? Use this free selector (beta) to compare virgin and glass-filled PTFE, recessed and non-recessed, with graphite slide plates for your service temperature and bearing pressure, and see which options suit.

Service conditions

Not sure of the pressure? Divide the vertical load by the sliding area, or use the PTFE Slide Bearing Calculator.

Sliding surface options

MaterialTemperature rangeMaximum pressureSuits these conditions?

For preliminary selection only. Values are from Benchmark’s published data: virgin PTFE up to 6.9 MPa (1,000 psi) non-recessed and 13.7 MPa (1,990 psi) recessed; glass-filled PTFE up to 18 MPa (2,610 psi) non-recessed and 50 MPa (7,250 psi) recessed; PTFE operating range −400°F to +500°F; graphite slide plates up to 2,000 psi, −50°F to 1,000°F in ambient air and up to 3,000°F in inert settings, recommended where temperatures exceed 300°F.

How to Choose a Sliding Surface

  • Virgin PTFE has the lowest coefficient of friction and suits most structural slide bearings at moderate pressure.
  • Glass-filled PTFE carries more load and resists wear and cold flow better, at slightly higher friction.
  • Recessed PTFE, set into a steel backing plate, carries much higher pressure than PTFE bonded to the surface.
  • Graphite slide plates are used where temperatures exceed about 300°F, such as furnaces, boilers, kilns and hot pipe supports, and keep working up to 1,000°F in air.

Related design tools: PTFE Slide Bearing Calculator  ·  Thermal Expansion Movement Calculator  ·  Cotton Duck Bearing Pad Calculator  ·  Specification Writer  ·  All engineering design tools

Products: PTFE slide bearings  ·  Graphite slide plates  ·  PTFE expansion bearings  ·  PTFE sheets

Request a Quote or Data Sheet

Send us your loads, movements and temperatures and we will quote PTFE or graphite slide bearings made in Canada. Call 800-580-4195 or use the form below.

BETAResults are estimates only. Verify them with your engineer or designer before proceeding. Found an issue? Let us know.