Canada flag
United States flag

Slotted Hole Calculator for Slide Bearings

Expansion ends of beams and girders on PTFE slide bearings need slotted holes so the anchor bolts don’t lock the bearing. Use this free calculator (beta) to size the slot from the bolt diameter, clearance and the expansion and contraction expected from the installation temperature, and see where to set the bolt in the slot.

Bolt and movement

Get expansion and contraction from the Thermal Expansion Movement Calculator. Clearance and allowance are your detailing choices.

Slot

Geometry only. The slot is in the moving member and the bolt is fixed to the support. When the member expands, the bolt moves toward the slot end nearer the fixed point; when it contracts, toward the far end. Check bolt strength, washer size over the slot, and the bearing and anchorage design separately.

How the Calculator Works

  • Slot width = bolt diameter + clearance.
  • Slot length = slot width + expansion + contraction + an allowance at each end.
  • Bolt position: if the member is installed at a temperature closer to one extreme, expansion and contraction are unequal and the bolt is set off-centre so it has room to travel both ways.
  • Movement comes from the coefficient of thermal expansion × length from the fixed point × temperature change. Use the Thermal Expansion Movement Calculator.

Related design tools: Thermal Expansion Movement Calculator  ·  PTFE Slide Bearing Calculator  ·  Bolt Length Calculator  ·  All engineering design tools

Products: PTFE slide bearings  ·  PTFE expansion bearings  ·  B8 Class 2 bolts

Request a Quote

Send us your bearing layout, loads and movements and we will quote PTFE slide bearings with slotted plates made in Canada. Call 800-580-4195 or use the form below.

BETAResults are estimates only. Verify them with your engineer or designer before proceeding. Found an issue? Let us know.